17
.
ge.
3) Make a hole in the inside of the
kitchen unit for the electrical cable to
feed through. Remove the screws
securing the extractor frame (B) to the
hood and unscrew the 2 lights. Ensure
that the two support clips on either side
of the hood are set to accommodate
the thickness of the mounting surface,
by adjusting the clip via the screw
4) Lift the cooker hood towards the
cut-out that you made in step 2. Feed
the electrical cable through the hole
that you made in step 3. IMPORTANT:
Do not connect the electrical cable to
the mains supply at this sta
5) Lift the cooker hood fully into the cut out that you made in step 2.
If you are connecting the cooker hood to external ducting, then secure
the ducting hose to the coupling on the appliance.
o
One person should support the hood. The other person should
fully tighten the support screws through the pre-drilled holes in
the outer frame of the hood, into the kitchen unit. Then replace
the extractor frame using the 2 screws (4 screws for GUH52)
(B) and reattach the 2 lights.
o
Refit the grease filter.
