2/7
THAN0210_Rev.1.00_E
Copyright(C)
2016 THine Electronics, Inc.
THine Electronics, Inc.
Security E
4.
Power Supply Setup
This chapter shows power supply condition.
Caution: Please check if there is no power-GND short on below red trace before supplying any power.
1.8~3.3V Power Supply to the Board
Evaluation board requires 1.8~3.3V power supply. Please use “CON201” connector typically.
Figure 2 THEVA827 power supply for evaluation board
Power Supply from / to Connector
power supply can be connected to Header201 and CON202 by using W201 and W202 solder jumper.
THEVA827
W201: Connect the power supply with pin#1, 2 and 3 of Header201.
W202: Connect the power supply with pin#29 and 30 of CON202.
Figure 3 THEVA827 power supply from / to each Connector
1.8~3.3V power supply
Ground
