MAINTENANCE
&
SERVICING
IMPORTANT
•
All servicing must be carried out by an approved competent person.
•
After each service the appliance must be checked for gas soundness
This appliance needs little maintenance other than cleaning. All parts should be cleaned using
warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders. When
cleaning the burner ring it is essential to ensure that the holes do not become blocked.
The control knobs are a push fit and can be removed for cleaning. They are interchangeable
without affecting the sense of operation.
Who To Contact
For service, please contact your authorised local Service Agent giving full details of the model,
serial number and date of purchase.
Manufactured by:
THETFORD Limited.
Unit 19 Oakham Drive,
Parkwood Industrial Estate,
Rutland Road,
Sheffield. S3 9QX. England.
Service Instructions
1. Disconnect from gas supply
Lift and remove the bottom plinth to gain access, then disconnect the gas supply.
If the appliance is Dual Fuel, disconnect/isolate the electric supply.
2. Remove hob surface
Disconnect from gas supply (1) and electric supply if Dual Fuel. Lift off the Panrest and
remove the two screws securing each burner spreader. Remove front fascia by
removing all push on control knobs and unscrew the two recessed fixed nuts and both
fascia retaining screws. Carefully lift off the fascia and if spark ignition fitted remove the
two spade connectors from the rear of the toggle switch. Remove the two central screws
securing the pressing to the rear box section. Remove the two front retaining screws
located each side and accessed through the outer slots on the angled front. Grasp the
hob by the angled front face, carefully lift the hob surface from the front to allow the rear
edge to unhook from the rear box section. Note:- On Dual Fuel appliances, remove the
hotplate rear cover and disconnect the power leads. The hob surface should be put onto
a suitable surface.
3.
Remove appliance from housing
Disconnect from gas supply (1). Open the oven door and remove the 2 screws from
each side trim - note the appliance can either be front or side fixed, see under
Fixing,
page 13. Open the glass lid and remove the 2 screws from each side trim. Carefully
slide the appliance out one third and check for any possible snagging of wires or pipes.
If the appliance is Dual Fuel, disconnect supply lead from rear terminal block. If OK, lift
appliance out onto a suitable surface.
14
