Thetford N614E.3F, Installation Manual

Page: 4 / 16

Installation / Owner’s Manual 4
Certified installation needs one lower intake vent and one upper exhaust vent. Install the upper exhaust vent either through the roof or
through the side wall of the vehicle exactly as written in this manual. Any other installation method voids both the certification and the
factory warranty of the refrigerator.
The bottom of the opening for the lower intake vent, which is also the service access door, must be even with or immediately below the
floor level. This allows any leaking LP gas to escape to the outside and not to collect at floor level.
While there are no maximum clearances specified for certification, the following clearances are necessary for correct refrigeration:
Bottom 0mm min. 0mm max.
Each Side 0mm min 3mm max.
Top 0mm min. 6mm max.
Rear 0mm min. 25mm max.
These clearances plus the lower and upper vents cause the natural air draft that is necessary for good refrigeration. Cooler air
comes in through the lower intake vent, goes up around the refrigerator coils where it removes the excess heat from the refrigerator
components, and goes out through the upper exhaust vent. If this air flow is blocked or decreased, the refrigerator will not cool
correctly.
Key Refrigerator Dimensions
These key refrigerator dimensions are for your reference as necessary (See Art02444).
Refrigerator cabinet width w/o trim:
583mm............. ..................................................1
Refrigerator width overall w/ trim:
624.8mm. ...........................................................2
Refrigerator cabinet to side trim:
21mm ..................................................................3
Refrigerator cabinet height w/o trim:
1407mm max.......................................................4
Refrigerator height overall w/ trim:
1454mm ..............................................................5
Refrigerator cabinet to top trim:
30mm ..................................................................6
Enclosure wall to hinges:
27.9mm ...............................................................7
Refrigerator cabinet to center of handles:
891mm ................................................................8
Art02444
8
5
1
7
2
6
4
3