Installation / Owner’s Manual 11
- Remove the three plastic hole caps that are near the strike plate.
- Remove the L-shaped plastic covers that are opposite the hinges.
- Remove and save the screws from the upper cabinet hinge [66a] of each door.
- Put each of these hinges on the other side of the refrigerator as the lower
hinge [66b].
- Attach each of these hinges with screws.
- Remove and save the screws from the lower cabinet hinge [67a] of each door.
- Put each of these hinges on the other side of the refrigerator as the upper
hinge [67b].
- Attach each of these hinges with screws.
- Remove and save the screw [41] from the control end cap.
- Pull the control end cap away from the refrigerator and out from under the control housing.
-
Carefully pull the button label from the front of the control housing and
set it aside. (See Art02459)
- Remove and save the two (2) screws from the control housing.
- Pull the control housing away from the display board assembly and set
the control housing aside.
- While holding the display board assembly, remove and save the two (2)
screws from the display board assembly.
- Move the display board assembly to the same hole position on the
opposite side of the refrigerator.
- Attach the display board assembly to the refrigerator using two (2)
screws.
Make sure that you do not pinch any wires and or loosen
any connectors from the display board.
- Align the holes of the control cover with the mounting holes on the display board assembly.
- Attach with two (2) screws.
Make sure that you do not pinch any wires.
- Align the button label with the recess in the control housing and press it into position.
- Put the strike plate on the opposite side of the refrigerator [65b].
- Put the three round plastic caps into the holes that are near the strike plate.
- Put the L-shaped plastic covers over the holes that were used by the hinges.
NOTICE
NOTICE
Art02446
69
68
41
41
Art02459
Summary of Contents for N614E.3F
Page 16: ...Installation Owner s Manual 16...
