6
OPERATION
Using the Hob Burners
Each burner is controlled individually and is monitored by a flame failure sensing device.
The respective knob positions for Full Rate, Low rate and Off are shown on page 3.
1.
Ensure gas supply is connected and turned on.
2.
To light: Push in the control knob and turn anti-clockwise to full rate – large flame on
control knob ( ) Fig. 1.
3.
Continue holding the knob depressed whilst holding a lighted match or taper to the
burner. For models fitted with Spark Ignition the procedure is similar except that the
burner can be ignited by depressing the ignition button located on the fascia.
4.
After the burner is lit continue depressing the knob for approximately 10 - 15
seconds before release.
5.
If burner has not lit within 15 seconds, release knob and wait at least 1 minute
before repeating operations (2) to (4).
6.
If required the knob can be turned further anti-clockwise to the simmer position. To
turn off, rotate the control knob anti-clockwise until the circle on the knob is aligned
with the dot on the fascia panel
Using the Grill
Control of the grill burner is identical to that used for the hob burners. Although the grill
does heat up quickly, it is recommended that a few minutes preheat be allowed. The grill
pan should be left in position to protect the base lining.
A reversible grill pan trivet enables the correct grilling height to be achieved.
•
DO NOT USE OR STORE FLAMMABLE MATERIALS IN OR NEAR THE
APPLIANCE.
•
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE
WHILE IT IS IN OPERATION.
•
WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR IN
CARAVANS, IT SHALL NOT BE USED AS A SPACE HEATER.
•
IF FITTED IN A CARAVAN OR MOTOR VAN, ALL BURNERS SHOULD BE
EXTINGUISHED WHEN THE VEHICLE IN WHICH THE APPLIANCE IS
INSTALLED IS MOVING. IT IS RECOMMENDED THE CYLINDER VALVE
TO THE APPLIANCE BE TURNED OFF.
•
When cooking keep children away from the vicinity. Turn pan handles
inwards so they cannot be caught accidentally.
•
On models fitted with a fold down lid, never operate the appliance with the
lid in the closed position.
•
Never leave fat or oil unattended on the hotplate.
•
When finished, check that all controls are in the off position.
