Data protocol
GBSOTXBA_V(1).DOCX
Page - 23
5.5.13 Counting frame: Clear counter value
Command byte
„V“
Description
Set the counter value to the start value.
Counting direction “up”: value is set to 0.
Counting direction “down”: value is set to the start value set
Parameter
-
Answer
Result byte: see chapter 5.3
Broadcast possible
yes
5.5.14 Poll operation mode
Command byte
„W“
Description
Returns the current operation mode of the control unit
Parameter
-
Answer
Result byte: see chapter 5.3
Parameter:
„0“: IN-SorTexx
„1“: OUT-SorTexx
„2“: Counting frame
Broadcast possible
Not applicable. Shelf number and compartment number are ignored
5.6 Examples
Remark: The blanks in the commands are only inserted for better legibility, they must not be actually sent.
5.6.1 One LED ON (without acknowledgement)
Command:
< 001 005 1 2 0 >
The yellow LED for shelf 1, compartment 5 is to be switched on.
Answer:
< 001 005 1 2 0 >
The command has been executed correctly.
5.6.2 One LED ON (with acknowledgement)
Command:
< 001 005 1 2 0 >
The yellow LED for shelf 1, compartment 5 is to be switched on.
1st answer:
< 001 005 1 2 C > The LED has been switched on (or the command saved in the buffer
memory).
2nd answer:
< 001 005 1 2 0 >
This answer comes after successful acknowledgement. The command is
now concluded.
5.6.3 All LEDs of all modules OFF
Command:
< 005 000 1 0 0 >
All three LEDs are to be switched off. The command applies to all modules
because “000” has been sent as compartment number.
Answer:
< 005 000 1 0 0 >
The command has been executed correctly.
5.6.4 Signal transducer ON
Command:
< 000 000 S 1 0 >
The signal transducer is to be switched on. This command ignores shelf
number and compartment number. Any values can be given.
Answer:
< 000 000 S 1 0 >
The command has been executed correctly.
5.6.5 Reset
Command:
< 000 000 R 0 0 > All modules are to be reset.
Answer:
< 000 000 R 0 0 > The command has been executed correctly.
