CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Burner Flame Check
• Remove cooking grates and flame tamers. Light burners, rotate
knobs from HI to LO. You should see a smaller flame in LO
position than seen on HI. Always check flame prior to each use.
If only low flame is seen refer to "Sudden drop or low flame" in
the
Troubleshooting Section
.
HI
LO
Turning Grill Off
• Turn all knobs to
position. Turn LP cylinder off by turning
hand-wheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP cylinder.
Press ignitor button rapidly.
"Click" should be heard and spark seen each time between
collector box or burner and electrode. See
"Troubleshooting"
if
no click or spark.
Valve Check
• Important: Make sure gas is off at LP cylinder before
checking valves
. Knobs lock in
position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to
LO
position then turn back to
position. Valves should turn smoothly.
Hose Check
•
Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
General Grill Cleaning
• Do not mistake brown or black accumulation of grease and
smoke for paint. Apply a strong solution of detergent and water
or use a grill cleaner with scrub brush on insides of grill lid and
bottom. Rinse and allow to completely air dry.
Do not apply a
caustic grill/oven cleaner to painted surfaces.
•
Plastic parts:
Wash with warm soapy water and wipe dry.
s
Do not use citrisol, abrasive cleaners, de-greasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
• Porcelain surfaces:
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use non-abrasive scouring
powder for stubborn stains.
• Painted surfaces:
Wash with mild detergent or non-abrasive
cleaner and warm soapy water. Wipe dry with a soft non-
abrasive cloth.
OFF
OFF
OFF
8 • 461821707
Sideburner Ignitor Lighting
s
Do not lean over grill while lighting.
1.
Turn on gas at LP cylinder.
2. Turn sideburner knob to HI, push IGNITOR button.
3.
Sideburner Match Lighting
If sideburner does NOT light, turn knob to OFF, wait 5 minutes,
then repeat lighting procedure.
1.
Turn on gas at LP cylinder.
2.
Place lit match near burner.
3
. Turn sideburner knob to HI. Be sure burner lights and stays lit.
Ignitor Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting.
2a.
2b.
To ignite side burner, turn side burner knob to HI .
3.
Push and hold ELECTRONIC IGNITION button.
4.
5.
To ignite, turn left knob to PRE-HEAT . Go to step 3.
If ignition does NOT occur in 5 seconds, turn the burner
controls OFF, wait 5 minutes, and repeat the lighting
procedure.
To ignite right burner, turn right knob to PRE-HEAT.
6.
If ignitor does not work, follow match lighting instructions.
Match-Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting.
2.
3.
4.
To ignite right burner, turn right knob to PRE-HEAT.
Place lit match into match holder, then into side of grill bottom
(as shown below).
Push in and turn ELECTRONIC IGNITION button to PRE-
HEAT. Be sure burner lights and stays lit.
After Lighting: Turn knobs to HI for warm-up.
