Thermopatch NL-15 R/SQR MAMMOTH, User Manual

Page: 9 / 39

thermopatch.com
9
6.0 Operating instructions
6.1 Operating the NL-15 R / SQR
You can work with the Mammoth when the machine is connected to the mains.
• Set the airpressure to 3 - 5 bar on the manometer.
• See paragraph 6.8 for information regarding the pressure settings required for the NL-15
R / SQR.
• Place the plug in the socket and turn ON the NL-15 R / SQR with the ON - OFF switch
which is placed on the back of the machine.
• Wait until the factory set temperature is reached.
Heating up will take approx 1 minute. The standard operating temperature has been set to
204 °C after which the press is ready for use.
6.2 Automatic mode
You can use the NL-15 R / SQR in Auto mode by pressing the AUTO -button The press cycle
will automatically start when the swivel arm is positioned above the press plate.
The robot symbol is shown in the display.

ATTENTION!
The automatic mode ( ) should be switched off, when you wish to change
the set values for temperature, pressure and press time.
When the automatic mode is activated, the key board will not respond.
6.3 Safety Frame
The upper platen of the press head of the NL-15 R / SQR is enclosed by a safety frame. This
frame will react if it is moved or touched and will interrupt the sealing cycle immediately.
Switch the machine off and on again to resume work.