![background image](http://html1.mh-extra.com/html/thermofisher-scientific/75002402/75002402_instructions-for-use-manual_1105582032.webp)
5
Maintenance and Care
Cleaning Intervals
5-2
Fresco 17 / 21
Thermo Scientific
Cleaning Intervals
For the sake of personal, environmental, and material protection, it is your duty to clean and if
necessary disinfect the centrifuge on a regular basis.
Cleaning
When cleaning centrifuge
•
Use warm water with a neutral solvent.
•
Never use caustic cleaning agents such as soap suds, phosphoric acid, bleaching solutions or
scrubbing powder.
•
Rinse the cavities out thoroughly.
•
Use a soft brush without metal bristles to remove stubborn residue.
•
Afterwards rinse with distilled water.
•
Place the rotors on a plastic grate with their cavities pointing down.
•
If drying boxes are used, the temperature must never exceed 50
°C, since higher temperatures could
damage the material and shorten the lifetime of the parts.
•
Use only disinfectants with a pH of 6-8.
•
Dry aluminum parts off with a soft cloth.
•
After cleaning, treat the entire surface of aluminum parts with corrosion protection oil
(70009824). Also treat the cavities with oil.
•
Store the aluminum parts at room temperature or in a cold-storage room with the cavities pointing
down.
Maintenance
Recommended Interval
Clean Rotor Chamber
Daily or when polluted
Clean Rotor
Daily or when polluted
Accessories
Daily or when polluted
Cabinet
Once per Month
Filter Unit
Every three Months
Ventilation Holes
Every six Months
CAUTION
Refrain from using any other cleaning or decontamination procedure than those
recommended here, if you are not entirely sure that the intended procedure is safe for the
equipment.
Use only approved cleansers.
If in doubt, contact Thermo Fisher Scientific.
Summary of Contents for 75002402
Page 42: ...6 6 Fresco 17 21 Thermo Scientific 6 Troubleshooting...
Page 51: ......