THERMOFILM AUSTRALIA 27 Rosalie Street, Springvale VIC 3171
Ph: 03 9562 3455 Fx: 03 9548 3979 www.thermofilm.com.au
E L E X
e u r o
C
O
N
V
E
C
T
I
V
E
P
A
N
E
L
H
E
A
T
E
R
S
4.4
Electrical connection
This heater is suitable for 230-240V.
Please observe national standards, the regulations of your local electricity supply company as well as
data on the rating label.
Electrical safety!
The ELEX
euro
convective panel heaters are IP24 protected against splashing water. In humid areas
such as bathrooms, the power socket must be installed at least 25cm above floor level.
Note the details on the rating plate!
The voltage supply must match the requirements on the rating plate. The supply cable must be
correctly sized. The heater must be connected to a socket outlet or permanent terminal box at least
10 cm to one side of the heater.
Please note in general:
Where the ELEX
euro
convective panel heater is fitted in a room with a bath or shower, ensure the
safety zone defined in IEE Regulations is applied in accordance with the details on the rating plate.
To avoid hazards, if the power cord of the appliance exhibits visible damage it must be
replaced by the manufacturer or his service agent or a qualified electrician.
4.5 Safety Notes
The ELEX
euro
convective panel heater is equipped with a safety cut-out that switches the heater off
if it overheats.
Once the heater has switched off due to overheating, remove the cause of the fault, e. g. blocked air
grids. When the heater has cooled down for several minutes it will restart automatically. If the heater
then cuts off again, switch off the heater and call an authorized serviceman.
5. Warranty
The below Warranty Terms and Conditions apply for
New Zealand and Australia only.
For
international warranty please refer to international warranty terms and conditions.
Thermofilm warrants to the original owner that ELEX
euro
products will be free from defects in
materials and workmanship for a period of 24 months for residential use from the date of purchase in
accordance with the following warranty terms and conditions. For commercial use warranty is 12
months.
Provision of this warranty is subject to:
•
The ELEX
euro
product must be installed in accordance with the Installation Instructions and
relevant electrical standards and codes.
•
The ELEX
euro
product must be maintained and cleaned according to instructions detailed in
the Installation Manual.
•
There is no warranty expressed or implied with regard to capacity requirements. The selection of
the unit or units depends entirely upon the system design and capacities as determined by the
purchaser.
•
The customer has not repaired, opened or altered the product in any unauthorised manner.
•
This warranty excludes damage to the product or components arising from circumstances outside
the control of Thermofilm, including, but not limited to, where the product is not used for intended
purpose; where the product has been rectified in any way; incorrect installation; incorrect power
supply; damaged caused during delivery; misapplication, misuse, abuse, vandalism, lack of maintenance
