THERMODYNE 2600DP, Installation & Operation Manual

Page: 18 / 24

— 18 —
Return
Manifold
Drain
Hose
Drain
Valve
Figure 11: Drain Hose
8. Place drain hose into pan or bucket and turn
valve to open position.
9. Once unit has drained completely turn valve
to off position and tuck drain hose back into
cabinet.
10. Reattach the left side panel.
11. Refill the unit with Thermodyne Heat Transfer
Fluid only. Never substitute with water or other
liquids.
12. Reattach the heater tank cap.
13. Restore power to the unit and place the Power
ON/OFF switch in its ON position.
NOTE: Unit may run briefly and shut off due to
low fluid level.
14. Remove reservoir cap and heater tank cap
and fill heater tank.
Reservoir
Heater
Tank
Figure 12: Fill Heater Tank
16. Repeat steps 12-14 until unit is completely full
of fluid.
17. Once unit is completely filled, reattach the
heater tank cap and the powerhead lid.
NOTE: If ADD FLUID light is on, add fluid to
reservoir tank until light goes out.
18. Allow the unit to heat until set temperature is
reached.
19. Once set temperature is reached, place the
power switch in the OFF position and let the
unit cool down to at least 100°F.
20. Turn unit back on, and if ADD FLUID light is
on again, add fluid to reservoir tank until light
goes out.
NOTE: Steps 18-20 are very critical in order to
purge any trapped air from the unit.