THERMODYNE 2600DP, Installation & Operation Manual

Page: 14 / 24

— 14 —
HOT WELL STARTUP
: The oven cabinet and hot
wells are hot. Use care when operating,
cleaning or servicing this equipment.
Once the cabinet is installed and electrical
connections have been made, thoroughly test the
Thermodyne cabinet before operation.
1. Check that all packing materials and other
items have been removed from the cabinet.
2. Press the Power ON/OFF Switches to the ON
position. The operating temperature will be
reached in approximately 30 minutes.
3. Check ADD FLUID Light.
• HOT WELL CONTROL: The light will come
on if there is no water in at least one of the
wells or the water drops below the water
level sensors. Add water to about ¾"
above the water sensors.
Water Sensors
Figure 5: Location of Water Sensors
NOTE: The controller has an OUT light (red
lamp). This light blinks as the controller
maintains the desired temperature.
Size, weight, pan loading, and product quality will
affect cooking times and should be adjusted to fit
the requirements of your operation.
Setting Temperature
1. To set temperature:
KEY FUNCTION
Up Key Press and release quickly to increase
the value of the displayed parameter.
Press and hold to accelerate
increment speed.
Down Key Press and release quickly to decrease
the value of the displayed parameter.
Press and hold to accelerate
decrement speed.
2. OUT light will illuminate while cabinet is
warming up.
3. When OUT light is blinking, the cabinet has
reached the desired temperature.
NOTE: The controller is not an indicator of fluid
level in the heater or reservoir tank.
Alarm 1 Indicator
Alarm 2 / Output 2 Indicator
Process Value Indicator
Process Unit
Indicator
A1 A2 PV
°C
°F
Set
Point
Value
Indicator
SV
Output 1
OUT
Indicator
Rubber buttons control
setup and set point adjustment.
Upper
Display
Displays
process value,
menu symbol
and error code.
Lower
Display
Displays set
point value,
parameter value
or control
output value.
Figure 6: Control Panel Functions
Preheating
Preheat the Thermodyne cabinet when first used
for the day or whenever the unit is cold. Preheating
takes approximately 30 minutes at which time the
temperature set point and the actual temperature
will display the same temperature. If the cabinet
has door(s), keep the doors closed during the
preheat cycle.