THERMODYNE 2600DP, Installation & Operation Manual

Page: 13 / 24

— 13 —
27. Press “UP” and the screen will display - tinE
1 / A 9:00 - alternately flashing.
(tinE 1 - A 9:00 = retherm time 9am/tinE - P
9:00 = retherm time 9 pm).
28. Press “VIEW” and the A 9:00 will appear. (To
change the time to 7am {for example} proceed
with the following steps.)
29. Press “DOWN” key and hold until A 7:00
appears. (The key changes in 1-minute
increments).
30. Press “ENTER” and the screen will display -
tinE / A 7:00 - alternately flashing (indicating
that the retherm time has been entered)
ALL PARAMETERS FOR MEAL 1 (M1) HAVE
BEEN SET AT THIS POINT. BY CONTINUING
THE PROCESS, ALL 5 MEALS (M1, M2, M3,
M4, & M5) CAN BE SET FOLLOWING THE
PROCEDURE OUTLINED ABOVE.
Press the “UP” (MANUAL CHILL) key and the
“SHIFT” key (black circle) simultaneously.
EXITING PROGRAMMING AND SETTING
THE TIMES AND TEMPERATURES JUST
ENTERED.
31. Press “ENTER” and Press “ENTER” again.
NOTE: If “EXIT is pressed it will void all the
information that was just entered into
the controller and default back to the
previously set information.
NOTE: If ErtM (error time) is displayed when
programming retherm times, an overlapping
retherm time has been scheduled. Go back
and check for the overlap, because the
overlap will not permit those overlapped
times to heat.
NOTE: When HOLD times and RETHERM times
overlap from a previously set start time,
the RETHERM time will take precedence
and will not give an error message.
NOTE: If any other messages occur, call Aladdin
Temp-Rite Service Department at 1-(800)
888-5426 for assistance as to their
meaning.
TO CEASE ANY HOLDING CYCLE AND TO
RETURN TO THE CHILL MODE:
Press the “UP”(MANUAL CHILL) key and the
“SHIFT” key (black circle) simultaneously.
HOT WELL CONTROLS AND
INDICATORS
All controls are located at the top middle front of
the Thermodyne cabinet:
• The control in the top middle of the
powerhead controls the Hot Well.
• The controls on the left and right of the Hot
Well control, operate the left and right oven
cabinets.
ITEM FUNCTION
ON/OFF
Switch
When lit, it indicates the unit is turned on.
ADD FLUID
Light (Red)
When lit, it indicates additional fluid is
required.
Controller
Provides readout of actual temperature
and desired temperature. It has increase
and decrease buttons for setting the
desired temperature.
In addition, a red OUT light blinks indi-
cating the desired temperature is being
maintained.
Controller Actual
Temperature
Decrease
Button
Increase
Button
Power
On/Off
Switch
ADD FLUID
ADD FLUID
Light
Set
Point
Output 1
Indicator
OUT
Figure 4: Hot Well Control Panel