Thermo Scientific TRACE 1300, Hardware Manual

Page: 488 / 624

9
Adding Modules
Adding a PDD Module
458 TRACE 1300 and TRACE 1310 Hardware Manual Thermo Scientific
Adding a PDD Module
This section provides instructions for adding a front/back PDD detector module. According
to the configuration of your TRACE 1300/TRACE 1310, a dummy module is present into
the free site where the detector module is not installed. See
Figure 476 .
Figure 476. Add a Front/Back Detector Module
Getting Started
To properly installing and connecting the PDD module see sequentially the following
sections:
• “Installing a PDD Module” on page 459
• “Plumbing the Gas Lines” on page 463
• “Installing and Purging the Gas Regulator” on page 464
• “Installing and Purging the Helium Purifier” on page 464
• “Connecting the Discharge Gas Supply” on page 465
• “Connecting the High Voltage and Pulses Cables” on page 465
• “Installing the Capillary Column” on page 470
• “Installing the Packed Column” on page 470
• “Testing for Leaks” on page 470
• “Performing Initial Power Up” on page 471
Dummy Back Detector Module
Dummy Front Detector Module
ATTENTION Where a dummy module is installed, the gas connection is blocked by a
plug.