7070iX TRO Analyzer
General Information | 3
General Information
The Thermo Scientific™ Orion™ 7070iX Total Residual
Oxidant Analyzer is an iodometric measurement system
designed in demand measurement of total residual oxidants
in process water in the range from 0.001 to 15 ppm. The
instrument responds to changes in oxidant concentration
within 30 seconds and detects residual oxidants in real time,
providing immediate feedback for water control mechanisms.
Safety Precautions
Thermo Fisher Scientific does not accept any liability for
damage that may arise if information in this manual is not
followed. Therefore, the operating instructions and
specifications must be read and understood by all personnel
involved in installation and operation of this equipment.
Thermo Fisher Scientific will not be liable for direct, indirect,
special, incidental or consequential damages resulting from
any defect or omission in this manual. Thermo Fisher
Scientific reserves the right to make changes in this manual
and the products it describes at any time, without notice or
obligation. Revised editions are found on the Thermo Fisher
Scientific website.
Intended operators should read and understand the entire
manual before operating this system. Special attention should
be given to all safety and caution notes contained in this
manual. Failure to do so could result in serious injury to the
operator or damage to the equipment.
The Thermo Scientific Orion 7070iX Total Residual Oxidant
Analyzer has been designed with careful attention to safety. It
complies with formal safety design rules established by
international regulatory agencies. Observe all safety warnings
marked on the instrument.
These warnings identify areas of potential hazard, which
could result in personal injury or loss of life.
To ensure that the protection provided by this equipment is
not impaired, do not use or install this equipment in any
manner other than that which is specified in this manual.
•
Do not use this product for any purpose other than
described in this manual.
•
Disconnect power before servicing and prior to making
any terminal connections within the analyzer enclosure.
•
Do not operate with the electronics enclosure door open.
Safety Information
Note:
Thermo Fisher Scientific is not responsible for any
damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and
consequential damages, and disclaims such damages to the
full extent permitted under applicable law. You are solely
responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a
possible equipment malfunction.
Symbols used in the
Manuals
Read all labels and tags attached to the instrument. Personal
injury or damage to the instrument could occur if not
observed. A symbol on the instrument is referenced in the
manual with a precautionary statement.
DANGER:
Indicates a potentially or imminently
hazardous situation which, if not avoided, will
result in death or serious injury.
CAUTION:
This symbol, in the context of a
CAUTION, indicates a potentially hazardous
situation which if not avoided could result in minor
to moderate injury or damage to the equipment.
Hot:
This symbol indicates that the marked area
can be hot and should not be touched without
care.
Earth (Ground):
This symbol, when noted on the
product, identifies the location of the connection
for Protective Earth (ground).
Voltage Warning:
The Orion 7070iX Total
Residual Oxidant Analyzer utilizes hazardous
voltages. The power source must be
disconnected before accessing the internal
components in the Display monitor or performing
any maintenance on this system. A mains power
disconnect must be provided in the area where
Orion 7070iX Total Residual Oxidant Analyzer is
located.
