Thermo Scientific F30400, Installation And Operation Manual

Page: 36 / 70

9
8 Segment & 4x16 Segment Programmable Models w/OTP
Controller Parameters
34
Large Tabletop Muffle Thermo Scientific
Controller Parameters
Home Display
°C : measured temperature in Celsius.

Temperature units cannot be changed without entering the configuration. Contact Customer Service if
a different temperature unit is required.
OP : % output power demand; displayed in lower display (cannot be changed).
C.id : Controller identification number.
PrG : Program number (displayed when a program is running; 4x16 programmable models only).
IdHi : Deviation High Alarm.
tunE : One-shot autotune enable.
run LiSt (Program Run List)
PrG : Currently running program (only used on 4x16 programmable models).
StAt : Displays the program status [OFF, run (running active program), hoLd (program on hold),
HbAc (waiting for process to catch up), End (program completed)] in the lower display. The controller
will default to “OFF.”
FASt : Fast run through program (no/YES). The controller will default to “no.”
SEG.d : Flash active segment type in the lower display of the home display (no/YES). The controller
will default to “no.”
ProG LiSt (Program Edit List)
PrG.n : Press the UP or DOWN ARROW to select the program number (program number will be
displayed in lower display on 4x16 programmable models only).
Hb : Press the UP or DOWN ARROW to select the holdback type [OFF (disables holdback), Lo
(deviation low holdback), Hi (deviation high holdback) or bAnd (deviation band holdback)] for the
entire program. The controller will default to “OFF.”
Hb.U : Press the UP or DOWN ARROW to select the holdback value (in display units).
rmP.U : Press the UP or DOWN ARROW to toggle between ramp units (Sec, min or Hour).
Controller will default to “Sec.”
dwL.U : Press the UP or DOWN ARROW to toggle between dwell units (SEc, min or Hour).
Controller will default to “SEc.”
Cyc.n : Press the UP or DOWN ARROW to set the number of program cycles (1 to 999 or cont). The
controller will default to “cont.”
SEG.n : Press the UP or DOWN ARROW to select the segment number (1-8 in 8 segment models,
1-16 in 4x16 models).