Thermo Scientific Dionex ICS-5000, Operator'S Manual

Page: 173 / 482

4 • DP/SP Startup
Doc. 065342-06 12/11
157
e. Select the RearSealWashSystem property and select the Interval
option.
f. For Chromeleon 6.8, click the Execute button.
4.8 Starting the Pump
1. Press the
POWER
button on the front of the DP/SP.
2. If any of the following conditions applies, prime the pump (see
Section 9.5 ) before proceeding:
•
The eluent has been changed.
•
The eluent line is new (empty).
•
The eluent line contains air.
3. On the Chromeleon 7 ePanel Set or the Chromeleon 6.8 panel tabset, click
the Pump tab to display the Pump panel (see Figure 4-7 ).
4. Enter the Flow rate required for your application. This starts the pump
flow, also.
Figure 4-7. Setting the Pump Flow Rate and Pressure Limits
(Chromeleon 7 Version Shown)
Enter a new flow rate
or click the switch to
start the pump at the
selected flow rate.
Enter the maximum
and minimum
pressure limits.