Section 7
Maintenance
Warning
Disconnect from the power supply prior to maintenance and
servicing.
s
Warning
Refer servicing to qualified personnel.
s
• While using the unit, occasionally check that both control panel status
lamps are functioning as described in the previous OPERATION
section.
• During normal operation, with controls properly set, the over-
temperature status lamp is not supposed to be functioning. If it is and
continues to be lit after recalibration as described in the previous
OPERATION section, follow the procedures described in the previous
TROUBLESHOOTING section to locate the source of the problem.
• Clean any spills immediately. Use only soap or mild detergent and
water with a soft cloth for cleaning. Do not use abrasives on the glass
inner door. Refer to following section for care of stainless steel surfaces.
• Wipe exterior with soft damp cloth as necessary to remove dust,
fingerprints or other smudges.
Warning
Electrolysis can damage stainless steel. This occurs when an
object is allowed to rest directly on the surface of stainless steel, trapping
moisture that becomes oxygen-starved, but is surrounded by water
containing oxygen.
s
High Performance Incubator 7-1
Thermo Scientific
Checking Controls
Cleaning
Care and Cleaning of
Stainless Steel