Disassembly and Reassembly
38
NOTE: Steps 3 through 6 must be performed
within 30 seconds to keep the neoprene
inside the bellows assembly from bonding to
the crankshaft.
3. Apply refrigerant oil to the bellows assembly
and install the centering washer, the spring,
and the bellows assembly.
4. Apply refrigerant oil to the primary ring and
place it in the bellows. Make sure to align the
notches.
5. Apply refrigerant oil to the front gasket and
place it on the compressor body.
6. Install the seal plate on the compressor. Hold
the seal plate against the spring tension of the
bellows until bolts are snug.
7. Torque the seal plate bolts in two steps using a
criss-cross pattern. See “Torque Values” on
page 24.
1.
Centering Washer
2.
Bellows Assembly
3.
Primary Ring
Figure 33: Spring Loaded Neoprene bellows Type
Seal
1.
Centering Washer
Figure 34: Seal Assembly Installation
1
2
3
ARC023
AGA549
1
1.
Notch Must Line Up
Figure 35: Align Primary Ring
1.
Gasket Must Seal Here
Figure 36: Gasket Positioning
1
AGA550
1