![background image](http://html1.mh-extra.com/html/thermo-king/t-1080s/t-1080s_maintenance-manual_1104340054.webp)
Operating Instructions for Premium HMI Control Panel
53
Switching from Electric to
Diesel
Units equipped with the Electric Standby
option only.
If the Electric to Diesel Autoswitch Enabled
feature in Guarded Access is set YES then the unit
will automatically switch to Diesel Mode
operation when standby power is turned off or is
no longer available.
If the Electric to Diesel Autoswitch Enabled
feature in Guarded Access is set NO then the
prompt screen in Figure 68 will appear when
standby power is turned off or is no longer
available. Alarm Code 91 Check Electric Ready
Input and Alarm Code 84 Restart Null will both
be set.
Figure 68: Prompt Screen, standby power is turned
off or is no longer available
Turn the unit off and back on using the OFF and
ON Keys. This will clear Alarm Code 91 Check
Electric Ready Input and Alarm Code 84 Restart
Null.
NOTE: The CLEAR Soft Key will not clear these
two alarms. Then the prompt screen shown in
Figure 69 will appear.
Figure 69: Prompt Screen, after OFF and ON
If YES is selected then the display will briefly
show the screen in Figure 70. Then Diesel Mode
operation will briefly be confirmed.
Figure 70: Display is YES is selected
If unit operation is required the diesel engine will
start as shown previously in STARTING THE
DIESEL ENGINE.
Initiating a Manual Defrost
Cycle
Defrost cycles are usually initiated automatically
based on time or demand. Manual defrost is also
available.
Manual defrost is available if the unit is running
and the evaporator coil temperature is less than or
equal to 45°F (7°C).
Other features such as door switch settings may
not allow manual defrost under some conditions.
To initiate a manual defrost cycle, press the
Defrost Key as shown in Figure 71.
Figure 71: Press Defrost Key
The display briefly shows [DEFROST],
[PROGRAMMING DEFROST - PLEASE
WAIT] and then [DEFROST STARTED].
Figure 72: Prompt Screen, Guarded Access Set to
Yes
The display then shows the Defrost display. The
bar indicator shows approximately how much
time remains to complete the defrost cycle. The
bar indicator in Figure 72 shows that the defrost
cycle is about 25% complete.
Summary of Contents for T-1080S
