Thermo IEC Micromax 3590, Service Manual, Page: 4 / 84

2
INSTALLATION
2.1
Receiving the Unit
IEC ships the centrifuge in a carton that protects it from
shipping hazards. Retain the carton and packing material
through the warranty period in case you need to ship or
return the unit. Please be sure to complete the Warranty
Registration Card and return it to IEC.
2.2
Site Preparation
The unit normally resides on a bench-top. The Micromax
(ventilated model) can be placed in a cold room (no colder
than 0
°
C) for processing temperature-sensitive samples.
When you remove the centrifuge from a cold environment,
allow at least two hours for any condensate to evaporate
before using.
Note: When used in a cold room environment, some
bearing noise may become evident. The bearing lubricant
thickens at low temperatures. As the centrifuge speeds
up, it is thinned and distributed more evenly. Once this
occurs, any noise should subside.
The Specifications at the end of this manual give the
dimensions of the unit. Provide clearance of 8 cm (3
inches) at the rear and on both sides for heat dissipation.
Provide clearance of 28 cm (11 inches) above the unit to
open the cover.
Place the unit on a clean, dry surface to ensure that the
suction feet grip the surface firmly. Be sure that the area
beneath the unit is clear of debris and loose materials such
as paper. The surface must be level to ensure quiet,
vibration-free operation. A stable location is important
since an improperly-loaded unit can vibrate and the
centrifuge must not be permitted to move during operation.
Micromax Series
2
Service Manual