15
15
ENGLISH
(*)
If the communication test fails the message “no COMM”
will appear
Once the initialization phase is complete, the display switches
to “basic display” mode.
In this mode, the main information on the equipment operation
is displayed. The meaning of the different icons displayed is
explained in paragraph “Control panel”. The icon and the
heating delivery temperature are displayed, either if the boiler
is in stand-by mode or if a temperature request is active (icon
blinking).
To switch off the equipment, set the main switch to “0”.
b
Never power off the appliance before switching the mas-
ter switch to the "0" position.
b
Never switch off the appliance with the master switch if a
request is active. Always make sure that the appliance is
in stand-by before switching the main switch.
Example of generator stand-by display in heating only
mode (external probe not connected)
Bar
°C
- Set the room thermostat to the required temperature (~
20°C) or, if the system has a timer or timer-thermostat,
make sure that this is switched “ON” and adjusted to
the required temperature (~ 20°C);
Adjustment of heating setpoint
- Press the key“+” or “-” to display the current value of the
heating temperature setpoint.
°C
- Increase or decrease the setpoint according to the type
of system by using the key “+” of “-”.
- To save the modification made and go back to the initial
screen, wait for 3 seconds or press the key “ENTER/
RESET”.
- Check that the thermal unit starts the ignition phase and
that the display shows the icon blinking (ambient
heating request) and the icon
.
- The boiler now starts up and the burner remains lit until
the temperature setpoint is reached.
Enable/disable the heating function
- Press the keys “+” and “-” simultaneously for a few sec-
onds;
- The icon and the current heating mode (ON or OFF)
will blink on the display;
- Press the keys “+” and “–” to select the required mode;
- Press the key “ENTER/RESET” or wait for 3 seconds to
save the modification made and go back to the initial
screen.
Enable/disable the domestic function
- Press the keys "
▲
" and "
▼
" simultaneously for a few
seconds;
- The icon and the current domestic mode (ON or
OFF) will blink on the display;
- Press the keys "
▲
" and "
▼
" to select the required mode;
- To save the modification made and go back to the initial
screen, press the key “ENTER/RESET”.
Adjustment of domestic setpoint
- Press the key "
▲
" o "
▼
" to display the current value of
domestic setpoint.
°C
- Increase or decrease the setpoint by using the key “
▲
"
o "
▼
".
- To save the modification made and go back to the initial
screen, press the key “ENTER/RESET”.
