42
ENGLISH
MAIN BURNER FUNCTIONS
CONTROLLED SHUTDOWN AND RESTART
After 24 hours of continuous functioning, the controller initiates
a controlled shutdown followed by a re-start to ensure that the
flame detector is not faulty.
You can reduce reduced shutdown and restart time to 1 hour
(see "Programming Mode").
POST-PURGING
The post-purging function keeps the fan running for a set time
after the burner shuts down provided there is no new heat re-
quest.
When the contacts of the heat request thermostat open, the
burner controller shuts down the flame and shuts off the oil
supply.
Post-purging does not occur:
- after a lockout;
- if a heat request is cancelled during pre-purging.
Post-purging occurs:
- if a heat request is cancelled during safety time;
- if a heat request is cancelled during normal functioning.
NOTE
If extraneous light or a false flame signal is detected during
post-purging, the burner locks out after 25 seconds.
If a new heat request is detected during post-purging,
post-purging time is reset, the fan motor stops and a new burn-
er ignition cycle is initiated.
PROGRAMMING MENU
General
You can use the reset or remote reset buttons to enter pro-
gramming mode only during NORMAL FUNCTIONING and
STANDBY.
If the reset or remote reset button is not pressed for 10 sec-
onds in menu mode, the controller automatically closes the
menu and the green LED flashes for the set value.
If you press the reset or remote reset button more than the
maximum permissible number of times, the maximum permis-
sible value is stored in memory.
If you press and hold the reset or remote reset button for over
60 seconds, a button error is displayed and the burner control-
ler resets itself.
Summary of Contents for 20109806
Page 1: ...ACQUAHOME 32 B 32 BS INSTALLATION AND MAINTENANCE MANUAL...
Page 57: ...57 ENGLISH...
Page 58: ...58 ENGLISH...
Page 59: ...59 ENGLISH...
