Figure 3
CONDUIT
EXTENDS PAST
FINISHED WALL
Figure 4
STEP 3: TOWEL WARMER INSTALLATION
A. Using (Fig 1) as your guide, locate and secure the
top Mounting Brackets to the horizontal header
using the (8) round slotted wood screws provided
(Fig 3). The screws should protrude a minimum of
1” into the header. Use suitable replacement screws
if the screws provided are not long enough.
B. Using (Fig 1) as your guide, make sure that each
conduit, or cable run, is aligned in the appropriate
location for each of the corresponding lower
Mounting Bracket locations. Drill 1/2” holes for
(8) toggle bolts. Now secure the lower Mounting
Brackets to the wall using (8) toggle bolts provided.
C. Using (Fig 4) as your guide, slide the Mounting Posts through
the hole in the Mounting Bracket Covers. Then take each
Mounting Post and hand-tighten each onto the threaded
Towel Warmer tube. Be sure to screw the Mounting Posts
entirely onto the threaded Towel Warmer tube.
DO NOT
force or cross-thread the Mounting Post onto the Towel
Warmer tube.
NOTE: AN ASSISTANT IS RECOMMENDED FOR THE
FOLLOWING STEPS
D. Have an assistant hold the towel warmer against the wall
and feed the wires from the lower Mounting Posts through
the hole in the lower brackets and conduit (if used) to the
controller box.
WARNING! DO NOT secure the small inner Mounting
Bracket screws into the rigid conduit until
after the final fitting of the Towel Warmer!
E. With the top and bottom Mounting Posts facing the top and
bottom Mounting Brackets, insert the Mounting Posts onto
the Mounting Brackets. If necessary, slightly unscrew any posts
so that the slots in all (4) Mounting Posts are aligned with the
small screws on the inner portion of the Mounting Bracket.
F. If all the Mounting Posts are not flush against the Mounting
Brackets, then remove the Towel Warmer completely from
all (4) Mounting Brackets and unscrew the uneven Mounting
Posts from the Towel Warmer until the ends of all (4)
Mounting Posts are flush with the wall.
NOTE: The Mounting Posts SHOULD NOT be unscrewed
more than 1/4” from the Towel Warmer.
Figure 3
Figure 4
Figure 2
Figure 2
LOWER MOUNTING
BRACKETS (x2)
