
Before use
Caution!
Always keep the unit in vertical position and on a firm flat surface at all
times.
Ensure that there is at least 300mm (1”) between the sides of the
appliance and any flammable, heating materials.
Do not place on soft surfaces.
Do not cover the appliance’s intake or outlet grilles.
For indoor use only.
Not suitable for use in cabinet, closet, boats, caravans or similar
locations.
Leave the unit to stand for one hour before connecting to the mains
supply after transport or when it has been tilted (e.g. during cleaning).
Do not obstruct the air intakes and exhausts.
The mains supply must conform to the specification shown on the rating
plate at the back of the unit.
Avoid overloading circuits, which is caused by using more electrical
amps than your wiring can support. Overloading electrical wires can
cause excessive heat and electrical fires.
Avoid the appliance from splash.
Examine the cord carefully. Make sure that it is not punctured or frayed.
Inspect the plug to ensure that the prongs are secure and the plastic
surrounding it is not cracked. Avoid running cords under carpets and
other areas where you cannot regularly check their condition.
Avoid over-twisting, -coiling, -pulling the power cord, never use nylon or
iron wire to tie the power cord.
Do not leave appliance when plugged in, unplug from outlet when not in
use and before servicing. Connect to a grounded outlet only.
If the supply cord is damaged, it must be replaced by an approved
service representative or a similar qualified person in order to avoid a
hazard.
The appliance shall be installed in accordance with national wiring
regulations.