4
www.thermaltronics.com support email: [email protected]
UNPACKING/ASSEMBLY/OPERATION
Please read this manual and follow the directions before using the equipment.
The carton contains:
1. Instruction manual
2. TMT-ST10 Solder Tip Tester
3. ST-SNSR-1 K Type Thermocouples (10 Pack)
4. ST-GWIRE Ground Wire (Power Plug style will depend on region)
5. ST-CABLE-1 Mini USB Cable
Important: Keep all shipping materials until satisfactory operation has been verified.
Assembly
1. Remove TMT-ST10 solder tip tester from its box and place on a suitable work bench.
2. Install a 9V battery into the back of the test meter.
3. Remove the ST-SNSR-1 K Type Thermocouples from the box. Place one thermocouple on the (6)
Thermal Sensor. Ensure that the sensor polarity Red (left) and Blue (right) are not reversed.
4. Optional: Remove the Ground Wire from the box. If voltage or resistance testing is needed,
connect one end to the (4) Ground Connection Socket. Connect the other end to the power strip
or socket, to which the soldering iron is connected. (see: System Features)
5. Optional: Remove the ST-CABLE-1 Mini USB Cable from the box. If test data output to computer
is needed, connect one end to the (3) Mini USB Port. Connect the other end to the computer
USB port and install data output software. (see: Software Functionality)
6. Switch the (1) Power Switch to the “on” position, the Thermaltronics Logo will display, followed
by the software revision number.
7. The tester is now ready to use.
Sensor (Red Polarity)
Sensor (Blue Polarity)
Test Temperature
Test ohm and mV
Sensor Release Lever
