2
www.thermaltronics.com support email: [email protected]
SYSTEM FEATURES
(8) Function Buttons
(2) LCD Display
(1) Power Switch
(5) Test Plate
Functions & Features
(1) Power Switch - Move up to switch ON, move down to switch OFF. The tester will automatically
go into sleep mode if not in use for 300 seconds.
(2) LCD Display - Displays test parameters and info messages. (see: Control Panel - LCD Display)
(3) Mini USB Port - Use the mini USB cable (ST-CABLE-1) to connect the TMT-ST10 to a
computer in order to read stored test data.
(4) Ground Connection Socket - For use when testing Tip to ground resistance (ohm) and tip to
ground leakage. Use the Ground Cable to connect the TMT-ST10 to the power strip or socket, to
which the soldering iron is connected.
Note: The tester must share the same ground as the soldering iron.
(5) Test Plate - Touch the Soldering Tip on the test plate to begin testing for Tip to ground
resistance (ohm) or Tip to ground voltage (mV) .
(6) Thermal Sensor - To test temperature, touch the thermal sensor with a soldering iron tip. Do not
push hard. If the sensor is damaged or oxidized it can be changed by pulling down the (7) Sensor
Release Lever, and then removing and replacing with a new sensor.
Note: Make sure that the sensor polarity Red (left) and Blue (right) are not reversed.
(7) Sensor Release Lever - Pull down on the lever to remove and replace the thermocouple.
(8) Function Buttons - Allows operation of the tip tester including configuration, test mode selection
and saving test data. (see: Control Panel - Function Buttons)
(3) Mini USB Port
(4) Ground Connection Socket
(7) Sensor Release Lever
(6) Thermal Sensor
