Page 6 of 19
INSTALLATION INSTRUCTIONS
UNPACKING
Remove packaging materials
•
Remove and dispose or recycle all packaging materials.
Remove tape and glue residue from surfaces before
turning on the air conditioner. Rub a small amount of liquid
dish soap over the adhesive with your fingers. Wipe with
warm water and dry.
•
Do not use sharp instruments, rubbing alcohol, flammable
fluids or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
•
Handle air conditioner gently.
1.
Remove air conditioner from carton and place it
on cardboard.
2.
Remove shipping screws from both sides of
cabinet.
NOTE: Do not lift, push, pull, or remove any expanded polystyrene
(foam)
from
inside
the
air conditioner. It is NOT packing material.
Window Installation (on some models)
NOTES:
•
Handle air conditioner gently.
3. Using 3 - #10 x 3/8” pan-head Phillips screws, attach top
•
Be sure your air conditioner cabinet does not fall out of the
channel to air conditioner cabinet.
opening during installation or removal.
•
The location where the power cord exits the air conditioner
Should be no more than 4 ft (122cm) from a grounded
3 prong outlet.
•
Do not block the louvers on the front panel.
•
Do not block the louvers on the outside of the air conditioner.
________________________________________________________
Attach Top Channel
________________________________________________________
NOTE: Attach top channel and side curtains to air conditioner
cabinet before placing cabinet in window.
1.
Locate supplied bag of screws.
2.
Place top channel on top of air conditioner cabinet, lining up
The 3 holes in top channel with the 3 holes on top of air
conditioner cabinet.
3.
Remove front panel by removing 2 Phillips head
screws on both sides of air conditioner.
4. Remove both knobs from control panel
5.
Remove ground screw and ground wire from
front of air conditioner base. Save ground screw.
6.
Pull on handle to slide air conditioner out of cabinet.
Place air conditioner on cardboard
