Thermal Dynamics SL100 HAND TORCH, Instruction Manual

Page: 26 / 92

INSTALLATION 3-6 Manual 0-2962
6. Connect the control circuit connectors on the Torch
Leads to the mating connectors on the Remote
Pendant Adapter and Power Supply Adapter (see
Warning).
WARNING
There are two additional connectors that are not
used and must be taped out of the way to prevent
contacting the Negative / Plasma or Pilot Leads.
7. Remove the top nut and washer from the Pilot
Stud on the power supply bulkhead.
8. Place the Torch Leads Pilot lead terminal on onto
the stud and secure with the nut and washer re-
moved in the above Step.
A-03675
Torch Lead
Assembly
Control Circuit
Connectors
Open
Open
Power Supply
Adapter
Pilot Lead Negative/Plasma
Lead
Adapter
Connector
Pilot Lead Stud
Negative/Plasma
Lead Connection
Note: Actual Bulkhead
configuration may
differ from that shown.
Remote Pendant
Adapter Wire Harness
Bulkhead Connection - Unshielded Machine Torch
with O2B Fittings and Remote Pendant Adapter
9. Connect the Torch Leads connectors and the re-
mote pendant adapter connector to the power
supply adapter as shown.
Remote Pendant
Adapter Wire
Harness
A-03676
Pilot Lead
Torch Lead
Assembly
Negative/Plasma
Lead
Control Circuit
Connectors
Open
Open
Power Supply
Adapter
Bulkhead Connection Detail - Unshielded Machine
Torch with O2B Fittings and Remote Pendant
Adapter
10. Tighten the Through - Hole protector onto the
Torch Leads or ATC Adapter Leads Assembly.
11. Connect the remote pendant to the remote pen-
dant adapter.
12. Check the torch for proper consumable parts.
CAUTION
The torch parts must correspond with the type of
operation. Refer to Section 4.04, Torch Parts Se-
lection.
D. Remote Pendant Control (Optional)
In mechanized applications an Adapter connects the
remote pendant control to the Power Supply.
Connect the remote pendant control cable to the torch
leads by aligning the control cable connector with the
adapter on the torch leads. Press the connector into
the adapter. Turn the locking ring to secure the con-
nection.