Page. 17
Electrical Wire Connection
1. Run a 120V AC, 15A circuit power cable or 20A for a
PHxxGWS product and the VTR1330 blower from the
service panel through one of the holes in the top
plate.
2. Connect black wire to power supply black wire, white
wire to power supply white wire and green wire to
green wire or bare wire.
3. Place all wiring connections inside the junction box
channel. Reinstall on the top plate. Ensure that the
wires are secure and that no wires are pinched.
EXTNCB25W 25 ft. Remote and In-line
Blower Extension Cable (optional)
Parts Included
•
1 – 25ft cable
•
2 – Adapter Cables (NOT NEEDED for all models)
Blower Extension Cable Connection
The internal blower harness should be routed through the
knockout and secured with a 1'' (25.4 mm) strain relief.
The remote harness can then be connected to the blower
harness outside the unit.
NOTE:
Cutting of the connector will void the warranty of
the appliance.
The blower extension cable is compatible with the
following In-line & Remote blowers:
Make-Up Air Damper Relay
Switch (optional)
Local codes may require the use of an additional backdraft
and/or make-up air damper. Contact your local HVAC
professional for specific requirements.
This hood provides a relay switch to connect a Make-Up
Air Damper (120V max). Installations will vary according to
the location in the home where the unit is installed and the
damper used. Use the following illustration as guidance
for your installation. Always comply with local code
requirements.
1. Access the hood’s wiring.
2. Route the Make-up Air Damper harness through the
strain relief to the terminal block.
•
The Make-up air kit hot and return connections
can use either terminal connection. There is no
polarity requirement for the two pin terminal
block.
3. Secure the ground wire with the green T-20 ground
screw.
White to white
Black to black
Green to green
or bare wire
Blower
SKU
Remote Blower
VTR630
Remote Blower
VTR1030
Remote Blower
VTR1330
In-line Blower
VTI610
In-line Blower
VTI1010
