Page. 14
4. Install the hood trim.
a) Hold trim flush to the bottom of the housing.
Secure the trim to the hood with (20) x 3/8''
(9.5 mm) screws.
b) The back trim piece may not be necessary in some
installation scenarios where there is a ½''
(12.7 mm) or less space between the hood and
the back wall.
5. Prepare for the wire routing.
a) Remove the junction box cover.
b) Remove one circular knockout.
c) Install strain relief (not included) into one of the
circular knockouts.
6. Install the unit.
a) Install the custom insert inside the custom
housing.
b) Secure to the rear of the housing framework using
six (6) x 1'' (25.4 mm) mounting screws, as
indicated below.
c) Secure to the top of the housing framework using
eight (8) x 1'' (25.4 mm) mounting screws, 4 per
side.
7. Connect to the ductwork.
8. Install the blower motor.
a)
Refer to “Choosing the Correct Blower” on
page 12
.
b) Refer to
“Blower Motor Installation” beginning on
page 15
.
9. Connect the electrical wiring.
a) Connect wiring for applicable blower motor (see
blower instructions beginning on page 15).
10. Install hood filters and grease trays.
a)
Refer to “Installing Grease Trays and Filters” on
page 19
.
11. Test the installation.
a) Test the operation of the blower and the lights.
b) Be sure to check for back-draft. With the blower
on high, close the windows and doors to the area
to ensure that fan does not cause back drafting in
any outlet vent for another appliance.
A
B
