REMOVING THE GLASS & DISPLAY HEAD
(“C” MODEL OVENS ONLY)
1.
Turn off the electrical power to the oven.
2.
Remove the control panel from the oven
(see pages 2-12 & 2-13) and position it face
down on a padded surface to protect the
finish.
3.
Disconnect the nine (9) cables from the left
and right touch control board connectors
(see Figure 16A).
4.
Remove the four control panel plate
screws (two on each end) and lift it and
the wiring off the control panel (see Fig-
ure 16A).
5.
To remove the glass and two touch con-
trol boards
, lift the glass off the control
panel (see Figure 16B). NOTE: The touch
control boards are part of the glass and
must be replaced with the glass.
6.
To remove the display head,
remove the
four screws holding it to the control panel
plate (see Figure 16C).
7.
Reassemble the oven.
REASSEMBLY NOTE: When you reinstall the
control panel plate over the glass, make sure
that the top of the display bracket is hooked
over the top edge of the glass to align it prop-
erly when the four screws are installed (see
Figure 16D). Keep the top edge of the glass
against the bracket
WARNING
Turn off the electrical power circuit to the
oven at the main junction box before ser-
vicing this unit.
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
CAUTION
Page 33
