
REMOVING THE OVEN TEMPERATURE SENSOR
Refer to Figure 10 for the following steps.
1.
Turn off the electrical power to the oven.
2.
To make servicing easier, remove the oven
door (see page 2-29).
Inline Splices
Oven Liner
Slide Fiber Sleeving Over
Wires & Against Collar Of
Oven Temperature Sensor
OVEN TEMPERATURE
SENSOR
Collar
MOUNTING
SCREW
WARNING
Turn off the electrical power circuit to the
oven at the main junction box before ser-
vicing this unit.
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
CAUTION
TECH
TIP!!
Be sure the oven temperature sensor connec-
tors are pushed back into the rear of the oven
and out of the oven heat zone.
3.
Remove the racks from the oven.
4.
Remove the screws from the bracket and
pull the oven temperature sensor forward
until the wire connectors are through the
opening.
5.
Cut the inline splices from the oven tem-
perature sensor and main harness wires.
6.
Connect the wires from the new oven tem-
perature sensor to the main harness wires
with two red inline splices. After you con-
nect the wires, pull on them to make sure
that the inline splices are secure.
7.
Use a screwdriver and push the wires into
the back of the oven as far as they will go,
then install the oven temperature sensor
in the oven liner with its two screws.
8.
Reassemble the oven.
Figure 10
Page 25