THERMACUT EX-TRAFIRE 30H, Operator'S Manual

Page: 16 / 56

EX-TRAFIRE
®
30H
Operator Manual, Revision T-15 3-16
Power supply location
Place the plasma arc power supply EX-TRAFIRE
®
30H on a flat even surface with a minimum distance
of 0�5m of clear space all round to ensure good ventilation�
Mains power connection
The EX-TRAFIRE
®
30H plasma arc power supply requires a 220 - 240 VAC single-phase mains power
source�
Connecting to an engine drive power generator
When using an engine drive generator to power the EX-TRAFIRE
®
30H:
•
Engine drive operation;
1� Set engine drive output to single-phase AC�
2� Plug the EX-TRAFIRE
®
30H mains power lead in to the power outlet�
3� Hard wire connection (No plug fitted) should be performed by a certified electrician�
4� Set the engine drive to maximum output (see chart below)�
5� For optimum performance, do not share the engine drive with other equipment such as
welding plant, lighting systems or angle grinders�
Single-phase, 50/60 Hz, 220 - 240 VAC
Input voltage Engine drive rating Current output
EX-TRAFIRE
®
30H
Performance
220 - 240 VAC 5 kW 30 A full arc stretch
Grounding
To reduce electromagnetic interference (EMI) and to ensure personal safety and correct operation,
the EX-TRAFIRE®30H must be correctly grounded through the mains power lead in accordance with
local and national electrical codes of practice� The single-phase service must be of the 3-wire type
with a protective green-yellow wire for protective earth ground and must comply with national and
local electrical codes of practice�
Mains power lead
EX-TRAFIRE
®
30H is supplied with a 3 meter length of 3 core 2�5 mm
2
flexo cable including moulded
plug (excluding the UK)�