SANTA FE OPTIONAL REMOTE HUMIDITY CONTROL
CAUTION
This should only be performed by a qualified electrician.
A 120Vac remote humidity control is available from the factory.
This replaces the factory mounted humidity control on the cabinet
of the dehumidifier, and allows the unit to accurately sense the
humidity in an area other than the one where the unit is located.
1. Unplug the unit.
2. Pull the black humidity control knob off from the side of the
unit, exposing 2 screws. Remove the screws.
3. Remove the front panel of the dehumidifier by removing 6
screws.
4. Remove the 4 screws securing the wiring box to the inside
of the blower end of the dehumidifier, and pull the box away
from the cabinet to allow access.
5. Insert a romex connector or conduit connector into the hole in
the cabinet that is left after the dehumidistat is removed. Pass
the cable to be used to connect to the remote dehumidistat
through the connector.
6. Disconnect the dehumidistat leads and reconnect with the
new wires.
7. Replace the wiring box and screws. Replace the front cover
and screws. Tighten any loose screws on the connector.
8. Run the new wire to the location desired to sense relative
humidity. Install a 120 volt (ac) dehumidistat according to
local electrical codes.
8
Santa Fe Installer’s & Owner’s Manual
9
Santa Fe Installer’s & Owner’s Manual
