Table of Contents
1. Specifications ........................................................................2
2. Installation .............................................................................2
2.1 Location .........................................................................2
2.1A In Humid Area, No Ducting .........................................3
2.1B In Humid Area, Duct Inlet and/or Outlet .........................3
2.1C In Remote Area, Duct Inlet & Outlet............................3
2.1D In Remote Area, Duct Outlet Only...............................3
2.1E In Remote Area, Duct Inlet Only .................................3
2.2 Electrical Requirements ..................................................3
2.3 Condensate Removal ......................................................3
2.4 Ducting ...........................................................................3
2.4A Optional Ducting ........................................................3
2.4B Ducting for Dehumidification ......................................3
3. Operation ...............................................................................3
3.1 Humidity Control Adjustment ..........................................3
3.2 Blower Switch ................................................................4
4. Maintenance ..........................................................................4
4.1 Air Filter .........................................................................4
5. Service ..................................................................................4
5.1 Warranty .........................................................................4
5.2 Technical description ......................................................4
5.3 Troubleshooting ..............................................................4
5.4 Refrigerant Charging ......................................................5
5.5 Blower Replacement .......................................................5
5.6 Compressor/Capacitor Replacement ...............................5
5.6A Checking Compressor Motor Circuits .........................5
5.6B Replacing A Burned Out Compressor .........................5
5.6C Replacing a Compressor - Nonburn Out .......................6
5.7 Humidity Control .............................................................6
5.8 Defrost Thermostat .........................................................6
5.9 Condensate Pump ..........................................................6
6. Wiring Diagram......................................................................7
7. Service Parts List ...................................................................8
8. Accessories List.....................................................................9
Optional Remote Humidity Control .............................................9
Condensate Pump Installation Instructions ...............................10
Ductable Inlet Mounting Detail .................................................11
Muffler Kit Instructions ............................................................12
Filter Installation Instructions ...................................................13
Warranty ..................................................................................14
Read the installation, operation and maintenance instructions
carefully before installing and using this unit. Proper adherence to
these instructions is essential to obtain maximum benefit from
your Santa Fe Elite dehumidifier.
When unpacking make sure to
remove corrugated shipping
cardboard from top of unit.
Specifications
Part Number:
4029720
Blower:
275 CFM @ 0.0" WG
Power:
700 watts @ 80°F and 60% RH
Supply Voltage:
115 volt – 1 phase - 60 Hz
Current Draw:
6.4 Amps
Operating Temp.:
56°F Min., 95°F Max.
Sized for:
2,500 Sq. Ft. - Typical
Minimum Performance at 80°F and 60% RH
Water Removal:
110 Pints/Day
Efficiency:
6.3 Pints/kWh
Energy Factor:
3.0 L/kWh
Air Filter:
MERV-11, Standard Pleat
Size:
16" x 20" x 2"
Power Cord:
9', 115 VAC, Ground
Drain Hose:
6' Direct Gravity Drain Hose (9/16" ID x 3/4" OD)
Refrigerant Type:
R410A (Refer to manufacturers label for
more information)
Refrigerant Amount:
1 lb. 7 oz.
Dimensions:
Unit Shipping
Width:
20" 24"
Height:
36" 44"
Length:
17"
21"
Weight:
110 lbs.
117 lbs.
CAUTION!
— This symbol means
important instructions. Failure to heed them can result
in injury or material property damage.
2. Installation
2.1 Location
The Santa Fe Elite is designed to be installed indoors and is
ideal for unfinished and finished basements. The Santa Fe Elite
is designed to operate in temperatures between 56° and 95°F.
Temperatures outside of these ranges will affect dehumidifier
performance.
In order to efficiently control the humidity levels, the area in which
the dehumidifier is to be placed must be free of water intrusion or
excessive fresh (outside) air infiltration. Before installing the Santa Fe
Elite, water intrusion and air infiltration problems should be addressed.
CAUTION!
• Installation outdoors or near a pool or spa will void
factory warranty.
• Do not use the dehumidifier as a bench or table.
2.1A In humid area, no ducting.
The simplest installation is to place the Santa Fe Elite in the
humid area with no ducting. The air inlet on top and outlet on
TABLE OF CONTENTS
2
Santa Fe Elite Installer’s & Owner’s Manual
Summary of Contents for Santa Fe Elite
Page 16: ......
