201M
11
10
cleaning & MainTenance
Cleaning External Surfaces
1. Turn off and unplug unit.
2. Use a washcloth slightly dampened with
a little water and dishwashing soap
to wipe the outer case surfaces.
3. Do not allow water to slip into the internal parts
as this could damage your unit and result in
electrical shock and injury to you.
4. Allow the unit to thoroughly dry before use.
Uv Lamp
The lifetime of the UV lamp is up to 12 months of
continuous, effective operation. After this time, the
bulb may remain illuminated, but its effectiveness
is greatly reduced.
For maximum germicidal
protection, please replace the Uv bulb annually.
If the lamp stops functioning or needs
replacement, please visit our web site at
www.envionproducts.com to order a
replacement lamp. Or call 1.800.875.8577.
Caution:
•
Do not touch the glass part of the lamp. Oil
from fingertips will decrease the effectiveness
of the lamp.
•
Never operate the unit without a filter or with
a damaged filter. UV lamp cover must be
installed at all times. The UV light from the UV
lamp will result in severe damage to eyes and
could cause blindness.
Uv Lamp Notice Warning:
UV Light is harmful to bare skin and eyes and can
cause temporary or permanent loss of vision.
Never look directly at the UV lamp while it is
illuminated-doing so could cause loss of vision!
Before replacing the Uv lamp, make sure the Therapure
®
air purifier
is turned off and unplugged.
Replacing the Uv Lamp:
1. Take out the two screws that secure the UV lamp cover to the bottom of the unit
and then remove the cover.
2. Pull out the UV lamp base assembly from the bottom of the unit.
3. Pull out the old UV lamp from the lamp base assembly.
4. Install the new UV lamp into the lamp base assembly.
5. Install the UV lamp base assembly into the unit. Make sure the UV lamp base assembly
snaps into place.
6. Install the cover and the 2 screws.
cleaning & MainTenance
TPP
201M
1.
4.
2.
5.
3.
6.
Summary of Contents for TPP201M
Page 10: ...201M 17 16...
