6
SITE REQUIREMENTS:
• The floor must be capable of supporting the total expected load (filled spa plus bathers).
Total filled weight of spa is approximately 1800 lbs.
• An adequate drainage system must be provided to deal with overflow water.
• Because of the combined weight of the spa, water, and users, it is extremely important that the base where the spa is installed is
smooth, flat, level and capable of uniformly supporting this weight for the entire time the spa is installed. If the spa is placed on a surface
which does not meet these requirements, any damage caused by improper support will void the warranty. It is the responsibility of
the spa owner to assure the integrity of the site at all times.
NOTE:
Do not install the spa on carpet or other material that can be damaged by moisture.
INDOOR INSTALLATION:
1. No matter where you install the spa, it is important you have a solid support foundation. If you are installing the spa outdoors, ensure
there are no sharp objects that could damage it and that the location is level so the spa sits stably and properly.
2. During filling, emptying or when in use, water may spill out of the spa. The spa should be installed near a ground drain.
3. Do not leave the spa’s surface exposed to direct sunlight for long periods of time.
A. Unfold the spa from the packaging. Spread the spa and cover. Make sure both are right side up.
GFCI TEST:
Before inserting the plug into a power receptacle, make sure the current rate of the power receptacle and the fixed wiring are suitable
for the spa. Contact a qualified electrician if you can not verify.
Insert the GFCI plug into a properly grounded power receptacle only.
1. Plug GFCI into power outlet, the indicator light should turn on.
2. Press TEST button, the indicator light should turn off.
3. Press RESET button again for use.
A.
