TLC-
2000
THERAPEUTIC MEDICAL LASER
Document: 600-0013
2
1
3.
Connect the 120 VAC hospital grade line cord (TLC-155) into the TLC-2003 Power Supply (or approved Hospital
Grade cord set for country of use) and then connect the TLC-2003 Power Supply into the power input located on
the Power Pack.
4.
Connect the Laser Probe(s) (TLC-2001) to the Power Pack (TLC-2002) by inserting the medical grade push-pull
connector to mate with the receptacle in the Laser Probe port.
Note: Port 1 MUST be used for one of the Laser Probes. Detailed instructions on how to connect the Laser
Probe to the Power Pack is given in section 3. Leave the Laser Probes turned OFF.
Note: Connect the Laser Probe(s) to the Power Pack PRIOR to switching the Power Pack ON.
5.
Connect the Computer Tablet power supply to the micro USB connector on the Computer Tablet and plug into a
120 VAC source. The power supply is universal and will need a plug adaptor for 240 VAC.
6.
Open the Computer Tablet and turn it on. Then log into the operating system with the supplied username and
password.
7.
Select the TLC-2000 icon and enter the username and password to start the application.
Note: There is a user name and password for the Computer Tablet and also for the TLC-2000 software.
8.
At this point the Theralase™ TLC-2000 Clinic Desktop screen should be displayed with icons for the actions.
9.
Turn on the Power Pack by:
a.
Turning the Emergency Stop switch a quarter turn clockwise to allow it to “pop” out
b.
Inserting the Remote Interlock Connector into its receptacle on the front panel of the Power Pack until it
locks firmly into place
c.
Turning the Key Switch 90° to the right
10.
At this point the Power Pack Power IN and Power OUT LEDs should illuminate.
11.
The system components are now set up and ready to be used.
Note:
The Theralase™ software must be operating with patient data in the database BEFORE the Laser
Probes will emit laser light.
Summary of Contents for TLC-2000 Series
Page 1: ......
