ThePondguy LEDPro Series Product Manual Download Page 2

Please read these instructions thoroughly before use. Failure to follow instructions may result in 

equipment damage or failure, losses, injury or death.

 DANGER: 

To avoid possible electric shock:
  •  If the power cord, lens, or other components have been damaged, DO NOT operate, LEDPro™ Lights 

should be replaced. 

  • Close supervision is necessary when the unit is used by or near children.

 WARNING: 

To reduce the risk of electric shock:
  •  Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit 

Interrupter and never remove the ground pin from the plug. 

  •  Provide a “drip loop” for the power cord. This is a loop in the cord below the level of the receptacle or 

plug that prevents water from traveling along the cord in the direction of the receptacle. 

  •  ALWAYS unplug the LEDPro™ Lights from power source when not in use, and before installing, 

removing or servicing the LEDPro™ Light’s components.

  •  If an extension cord is necessary, a cord with a proper rating should be used. A cord may overheat if 

the cord is rated for less amperes or watts than the unit rating.

  • DO NOT immerse the LEDPro™ Light’s plug in water or attempt to use a wet plug. 
  •  The LEDPro™ Lights are NOT suitable for use in swimming pools, swimming ponds, or other 

situations where bodily contact is made with the water. 

Important – LEDPro™ Lights may be used in or out of water. When used in open air application, 

unplug the lights and allow to cool before servicing. 

 CAUTION: 

To reduce the risk of equipment damage or failure:
  •  DO NOT place LEDPro™ Lights near flammable or other dangerous materials or objects.
  • DO NOT use the LEDPro™ Lights in fluids other than water.
  •  DO NOT exceed the voltage and wattage indicated on the transformer.
  •  DO NOT operate during freezing conditions. Remove LEDPro™ Lights and store in a protected 

location. 

  

The Pond Guy® is not responsible for equipment damage or failure, losses, injury or death resulting 

from failure to follow safety precautions, misuse or abuse of equipment.

MODEL

# OF LIGHTS

WATTAGE

ITEM 

NUMBER

LEDPro™ Mini 1-Watt

3

3x1 Watts

120813

LEDPro ™ 3-Watt

3

3x3 Watts

120810

LEDPro ™ 6-Watt

3

3x6 Watts

120817

LEDPro ™ 12-Watt

1

1x12 Watts

120828

thepondguy.com  |  866-POND-HELP (766-3435)  

2

Summary of Contents for LEDPro Series

Page 1: ...llingYourLEDPro Lights 3 MaintainingYourLEDPro Lights 4 Troubleshooting 4 WarrantyInformation 4 Table of Contents For Models LEDPro Mini 1 Watt Light Kit 3 Pack Item 120813 LEDPro 3 Watt Light Kit 3 Pack Item 120810 LEDPro 6 Watt Light Kit 3 Pack Item 120817 LEDPro 12 Watt Single Light Item 120828 ...

Page 2: ... may overheat if the cord is rated for less amperes or watts than the unit rating DO NOT immerse the LEDPro Light s plug in water or attempt to use a wet plug The LEDPro Lights are NOT suitable for use in swimming pools swimming ponds or other situations where bodily contact is made with the water Important LEDPro Lights may be used in or out of water When used in open air application unplug the l...

Page 3: ...he Splitter B cord into the Transformer A and tighten plastic retaining nut Step 3 Place Lights C in desired locations Step 4 Make sure Photocell E is located out of the water in an area exposed to natural light Step 5 Plug the Transformer A into a standard 110 volt outlet with GFCI B E A 3 16 16 16 C D LEDPro 1 3 6 Watt Light Kits A Transformer B Splitter C Light D Lens E Photocell E A 16 C LEDPr...

Page 4: ... photocell Lights stay on during the day Make sure photocell is upright unobstructed exposed to sunlight PRODUCT WARRANTY LEDPro Series High Output Lights carry a 3 year warranty The Pond Guy will repair or replace any units found to be defective This limited warranty is extended exclusively to the original purchaser and begins from the date of original purchase receipt Abuse or misuse of this pro...

Reviews: