QUICK START GUIDE - SB25 MOUNT ADAPTER
FIGURE 5. Using supplied 3mm hex wrench,
tighten all screws securely.
4 - POSITION ADAPTER
While the machine screws are all still loose, position the
adapter so that the round cutout aligns with the loudspeaker
input terminal cup. This will position the ADAPTER at the
loudspeaker center-of-mass.
Figure 4a
.
When the adapter is positioned correctly it will appear as
shown in
Figure 4b
.
7 - ATTACH THIRD PARTY MOUNT PLATE
Make sure you purchase a speaker mount that can support
25lbs with a mount hole pattern of 2.00” x 4.25” or 2.75”
x 5.00”.
If using a VESA mount (monitor arm or similar) you can
use the 75mm or 100mm VESA square hole pattern in the
ADAPTER.
Attach the third-party speaker mouting bracket mount
plate using the supplied 1/4”-20 or M5 (for VESA mounts)
hex socket cap screws and lock washers as shown. Your
speaker mounting bracket mount plate may look different.
Figure 7a.
For extra security, install the nylon lock nuts, or “jam nuts”
onto the screws on the back side of the adapter.
Figure 7b.
Once the third party mount plate is attached, attach speaker
to speaker mount according to mount manufacture’s
instructions.
5 - TIGHTEN ALL SCREWS
Once you’re satisfied with the ADAPTER position, use
supplied 3mm hex wrench to tighten all 4 machine screws
securely.
Figure 5.
FIGURE 7a. Mount third-party mounting plate
using supplied cap screws and lock washers.
FIGURE 4a. Align rounded cuout with terminal input cup.
PAGE 4
ATTACHING ADAPTER (CONT’D)
Align
FIGURE 4b. ADAPTER positioned
correctly.
ATTACHING THIRD PARTY SPEAKER OR VESA MOUNT
FIGURE 7b. Once cap screws are tight, install
jam nuts on the rear side of the adapter.
