Themis GbE XMC, Installation Manual

Page: 31 / 38

A-7
Themis Computer
A—Connector Pinouts and LEDs
Front-Panel LEDs
A.4.1 PCB LEDs
The GbE XMC Ethernet Card had three LEDs on the bottom side of the PCB. The
locations of the LEDs can be seen in
Figure A-5 below. The LED color and descrip-
tion is located in Table A-4 on page A-8.
Figure A-5. GbE PCB LEDs (Bottom Side)
S
D8
D9
D7
(Not Used)
Note: Cable connection (P16) to 2PX2
Carrier Board is not used in a typical
configuration. Preferred connection
method is through the XMC connector
Heat sink and accompaning holes
not currently used. Please contact
Themis if a heat sink solution is
required.
Legend
Board LED
= Actual location
of solder beads
= Color of the LED
= Component ID
D1
D1