PARLOUR 3000-MV
DIRECT VENT GAS HEATER
22
FIGURE 7 – LOCATION OF PILOT, BURNERS, AND LOGS
Burner and Pilot Checks
A periodic check of the pilot and burner flames should be made. Check after
the fire has been on for at least 30 minutes. The pilot flame must cover the
tip of the thermocouple and thermopile probes. If the pilot flame does not
sufficiently cover the probes it can be adjusted using the pilot adjustment
screw found on the front of the gas valve. The main burner flame pattern will
vary from appliance to appliance depending on the type of installation and
climatic conditions.
Note: Burner must
be removed to
access air shutter
(See Appendix B)
Summary of Contents for PARLOUR 3000-MV
