15
Menu Entries:
•
SEn - Sensitivity: Hi(gh) / Low
Default: High. Set it to Low if you have problems with disturbing
sources like fluorescent or strobe lights.
•
AvG - Averaging: Hi(gh) / Low
Default: Low. Set it to High if you need to have more stable
readings under difficult atmospheric conditions.
•
Unt - Unit: mm / cm / in(ch) / f(ract). in(ch)
Default: mm. Choose desired numeric elevation display unit.
•
o.o.b - Out of beam display: On/OFF
Default: OFF. Switch Out-of-beam display on and off. A
sequence of arrows indicates if the receiver has moved beyond
the vertical reception range and will indicate in which direction
to move to get back to the laser beam.
•
Inf - Device Information
Find Information about Firmware Version (Fw), Device Code
(dc) and Serial Number (Sn) here.
NOTE: All menu settings will be retained when the receiver
is turned off.
Power supply of detector
If the battery display is shown on the LCD, you should change the
battery (1xAA) otherwise, the range may be limited.
Open the folding lid of the battery compartment to change the
battery.
Dispose of used batteries correctly (see point 7) and ensure the
correct polarity with the new batteries (observe the symbols).
