P.10
3
Main Wing
(Lower)
15
Note : It is recommended that the wing tube stays with the left wing. Removal of the wings could be achieved by
removing the right wing machine screw, the right wing then the left wing with wing tube. If removal of wing tube
from left wing is also required, it is recommended that instead of applying self-tapping screw in step 3, you pre-
tap with M3 thread cutter and apply M3 machine screw.
Step 1. Insert the aluminum wing tube (
Ø
22x865.5mm) with the pre-drilled hole end into the right wing (lower).
Align the lines marked at the wing root and wing tube, then apply the PM3x22mm machine screw through the
pre-drilled hole on top of the wing. (Please confirm the alignment of the hole by putting a 2.5mm diameter rod
through the pre-drilled wing hole before applying the screw.) The hole on the wing tube is pre-thread, do not
over tighten the PM3 screw, the set up is for future removal of the wing.
Wing Tube
Ø
22x865.5mm
≈
255mm
Main Wing (Lower)
1
Step
≈
165mm
Step 2. Install the right wing to the fuselage by inserting the wing tube (now attached to the right
wing) through the fuselage, then install the left wing.
S t e p 3 . M a k e s u r e t h e w i n g s a r e r e s t i n g a g a i n s t t h e f u s e l a g e t i g h t l y. L o c a t e t h e p r e - d r i l l e d 2 m m h o l e a t
t o p o f l e f t w i n g , a n d d r i l l a l o n g w i t h 2 . 5 m m d r i l l b i t u n t i l i t p a s s e s t h r o u g h t h e w i n g t u b e . A p p l y t h e
PA 3 x 2 2 m m s e l f - t a p p i n g s c r e w .
d3 x D7mm
Washer
PM3x22mm
Screw
1
2
PA3x22mm
Screw
1
PM3x22mm d3 x D7mm
Washer
Top View
Top View
2
Step
PA3x22mm
d3 x D7mm
Washer
Left
Right
3
Step
2.5mm
