Note;
If you wish to pass the RCA / Phono plugs through
the plinth you will need to feed them through the slot at this
stage. See below
But we don’t recommend doing this on initial installation as
it is easier to lift the arm off for adjustment. Get it running
first.
Fitting The Wand Tonearm Mount
Step 1;
Feed the bolt down to the boss on the
clamping plate and do up loosely (but not tighten yet).
Two screw lengths are provided for different plinth thickness.
The lower clamping plate may go either way up.
Step 2;
Remove rubber transit cap.
Step 3;
Position mount using protractor.
Step 4;
Tighten to clamp.
(Rotate to get in the correct place). Use supplied hex key
www.thewandtonearm.com
© Feb 2017 design
build
listen Ltd. v17
C
Hint; Cueing with The Wand Tonearm
We suggest using the side of your finger.
Rather than trying to grip the tip
.
Other Protractor systems;
If using another brand of
protractor. The centre of the
pivot is aligned with the
shoulders of the main body
.
