-2-
INSTALLATION OF BATTERIES
Place the set face down on a flat surface.
Release mounting screw by screw driver
then depress the battery door and slide it
until it comes out (Follow arrow direction)
then lift up the door.
Insert 4 C-cell batteries (not included) into
the battery compartment. For longer
battery life, we suggest the use of Alkaline
type batteries.
Close the battery door and tighten
mounting screw.
1.
2.
3.
DC JACK
Use 6 volt AC Adaptor and insert into DC
Jack on side.
CASSETTE TAPE
Use only cassette tapes not exceeding 60
minutes (C-60) in length or the prerecorded
cassette tapes with background music from
our Tape Club.
CASSETTE INSERTION
Before inserting a cassette, take up any
slack in the tape by inserting a thick pencil
into the hub of the cassette and turning it
a few times.
Press STOP/EJECT key to open cassette
door.
Place cassette in the holder on the inside
of the door, tape facing up with the
desired side to play or record towards you.
NOTE: Be sure cassette is inserted
properly.
Close the cassette door.
1.
2.
3.
4.
When the recorder is operated in recording,
previous recordings are automatically erased.
For this reason, cassettes have incorporated
a safety device to prevent accidental erasure.
When the small tabs at the rear of a cassette
are broken out, an interlock on the recorder
will be activated, hence preventing recording.
To protect a recording on one side, break out
the tab on that side: Likewise for the other
side. When the cassette is installed with the
tab broken out the RECORD Key cannot be
depressed. To reuse a cassette for recording
after the tabs have been broken, simply cover
each slot with a small piece of cellopane or
vinyl tape.
TO PLAY A CASSETTE TAPE
Turn VOLUME CONTROL to
"
ON
"
position.
Insert a prerecorded cassette tape.
Turn FUNCTION selector (TAPE/SAL/
MIC) to
"
TAPE
"
position.
Depress PLAY key.
Adjust VOLUME CONTROL knob for
desired level of sound.
TO RECORD
Turn VOLUME CONTROL to
"
ON
"
position.
Insert a fresh blank cassette tape.
Turn the FUNCTION select (TAPE/SAL/
MIC) to
"
MIC
"
position.
Depress PLAY and RECORD (REC) keys
to start recording.
NOTE:
Remember to turn the VOLUME
CONTROL on Microphone to
"
ON
"
position
and adjust to middle or maximum level when
recording.
SING-A-LONG FUNCTION
Sounds from our prerecorded cassette tapes
with professional background arrangements
can be mixed with your voice from Sing-A-
Long Microphone (MIC). This can give you
exciting listening pleasure and enjoyment. In
addition, Sing-A-Long also amplifies your
voice although the speaker.
To Sing-A-Long with you favourite music
follow these steps:
With prerecorded tape
1.
Put a prerecorded cassette tape into the
cassette compartment.
Insert the Microphone plug into the Mic
Jack at side of unit.
Set FUNCTION selector to SAL
position.
Adjust VOLUME CONTROL to
appropriate sound level.
NOTE:
If a squealing (feedback) sound is
heard reduce the MIC volume or increase
distance between MIC and speaker.
Press PLAY key to activate the tape,
and you can sing-a-long with your
favourite music through the microphone.
