04/2021 V 1.0
VIEW 19F
WARNING
The glass is heavy and may
damage the
fl
oor or underframe if
handled incorrectly. It is advisable
to use a suitable non-slip
protective mat or piece of carpet.
Never rest the glass across the
underframe as this may cause
damage.
06/14
Using purpose built "Glass Lifters",
position and sit the Glass Return Panel
on to the Underframe Gasket and push
against the Inline Panel.
Note the orientation and position of
the Panel, this can be determined by
any holes or attached labels.
Remove and replace the Panel adding
or subtracting spacers as necessary to
level the Panel (to a maximum height
of 5mm inside the Underframe).
Check the Panel is level using a Spirit
Level. If the difference between the
two Panels is greater than 5mm, it may
be necessary to lower the Return
Panel.
Mark/scribe the Underframe at the top
face of the Glass Panel.
DO NOT trim the Profile at this stage.
Carefully lift the Glass Panel out and
put to one side. Remove the Inline
Panel, Wall Profile Soft Seal, Wall
Profile, Underframe Gasket, and
Underframe Profile and set to one side.
21
22
23
24