15
OPERATING INSTRUCTIONS
Storage
• When your pressure washer session has been
completed, turn off the power switch. Unplug the
power cord from the outlet. Turn off the water supply.
Pull the trigger on the spray gun 2-3 seconds to drain
out the excess water and to release any remaining
water pressure. Do not allow the power washer to run
with no water flowing through it.
• Remove high pressure hose from spray gun and
unscrew the other end of the high pressure hose from
the power washer.
• Remove lance from the gun. Place the gun in the
holster on the side.
• Make sure to discard any remaining detergent from
the tank. Residual chemical will stick to the container
which could become contaminated, and can cause
the detergent injector to clog and not function
properly. Flush the tank and nozzle head with clear
water to prevent clogging.
• Wind the power cord around the L-shaped hooks
located on the top of the machine.
• The pressure hose is stored on the hose hook located
on the back of the handle.
• DO NOT store the power washer where it is
exposed to freezing temperatures unless you use
an antifreeze designed for pumps.
Store the power
washer indoors to prevent the water in the unit from
expanding under freezing conditions. When the
water freezes and expands, your power washer will
be damaged and become inoperable. Or, if storing
outdoors, it is recommended you use pump saver (not
included) to protect pumps.
CARE AND MAINTENANCE
OPERATING INSTRUCTIONS
VER
PUMP SAVER
Pump Saver
is a product that protects and prolongs
the life of the pump. This will keep the internal parts
of the pump lubricated and protected from freezing
while being stored in ALL climates. It also assists with
protection from internal corrosion.
Pump Saver Instructions
Turn unit off and disconnect the hose and gun before
adding pump saver. Unscrew threaded top from bottle
to remove seal and reattach threaded top to bottle.
Remove black cap from bottle.
1) Place top of pump saver bottle onto the garden hose
adapter previously installed on the pressure washer
inlet.
2) Secure pump saver bottle by turning in a clockwise
direction.
3) Turn the power on.
4) Squeeze bottle to help it into the pump.
5) Turn power off when pump saver exits the
machine’s water outlet.
Note:
Instructions on Pump Saver Bottle are generic and
not model specific
2
1
